CAT 627G Manual de usuario descargar pdf (Pagina 9)

Visibility. Hood and front shroud

width increased to accommodate the

low emission engine, the air-to-air

aftercooler (ATAAC), ether starting aid,

and lights. Hood corners are sloped to

maintain the same level of visibility as

the E-Series.

Single Lever Implement Control.

Simple and easy to operate, the joystick

enhances the productivity of operators

of all skill levels. Requires less force to

control the critical scraper functions and

requires less lever travel. Grab handle/

hand rest next to joystick controller so

operator has a place to rest hand while

on the haul and return roads.

1) Bowl (forward & back)

2) Ejector (side to side)

3) Thumb rocker switch

• Apron position

• Elevator direction, speed

4) Transmission Hold

5) Cushion Hitch

6) Trigger* (not shown here –

is on front of joystick)

• Auger (on/off)

• Push-Pull (bail up/down)

• Elevator (on/off, resume)

* Standard open bowl does not have

a trigger

Instrument Display Panel. Features a

quad-gauge layout showing engine

coolant temp, transmission/torque

converter oil temp, fuel level, and

system air pressure. The 627G tachometer

can monitor either front or rear engine

speeds. Once the 627G tractor engine

has been started, the operator can start

the rear engine from inside the cab.

EMS III can display both front and rear

engine information right in the cab.

Logical Control Placement. Frequently

used switches and indicator lights are

on the instrument panel, and less

frequently used switches on the

overhead console.

Engine Speed Lock Controller.

Enhances operation during long haul

cycles by allowing the operator to

maintain a desired engine speed without

maintaining pressure on the accelerator.

Simplified Transmission Control.

Simplifies gear selection (1st, 2nd,

Drive and Reverse) and allows

operator-defined top gear control.

Relocating the gear control to the

rear increases operator legroom.

9

1

4

5

3

(Down)

1 (Up)

2 (Forward) 2 (Return)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comentarios a estos manuales

Sin comentarios